beautypg.com

Configuring cwmp at the cli, Enabling cwmp, Configuring – H3C Technologies H3C WX3000E Series Wireless Switches User Manual

Page 57: Cwmp at the cli

background image

48

Configuring CWMP at the CLI

You can set CWMP parameters at the CLI.

NOTE:

The configurations made through ACS, DHCP, and CLI are of decreasing priorities. You cannot use a
configuration mode to modify parameters configured through a configuration mode with higher priority.
For example, the configurations made through ACS cannot be modified through DHCP.

Complete the following tasks to configure CWMP at the CLI:

Task Remarks

Enabling CWMP

Required.

Configuring ACS attributes:

Configuring the ACS URL

Required.
Supports configuration through ACS,
DHCP, and CLI.

Configuring the ACS username and password

Optional.
Supports configuration through ACS,
DHCP, and CLI.

Configuring CPE attributes:

Configuring the CPE username and password

Optional.
Supports configuration through ACS and
CLI.

Configuring the CWMP connection interface

Optional.
Supports configuration through CLI only.

Configuring the CWMP connection interface

Optional.
Supports configuration through ACS and
CLI.

Configuring the maximum number of attempts made to retry a

connection

Optional.
Supports configuration through CLI only.

Configuring the close-wait timer of the CPE

Optional.
Supports configuration through CLI only.

Enabling CWMP

CWMP configurations take effect only after you enable CWMP.
To enable CWMP:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter CWMP view.

cwmp

N/A

This manual is related to the following products: