H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 68)

59
• If the timestamp starts with an asterisk (*), the information is debugging information
serial number
This field indicates the serial number of the device that generates the system information. It is displayed
only when the system information is sent to a log host in the format of UNICOM.
source
This optional field identifies the source of the information. It is displayed only when the system information
is sent to a log host in H3C format. It can take one of the following values:
• Slot number of a card
• IP address of the log sender
content
This field provides the content of the system information.
Information center configuration task list
Task Remarks
Outputting system information to the console Optional.
Outputting system information to a monitor terminal Optional.
Outputting system information to a log host Optional.
Outputting system information to the trap buffer Optional.
Outputting system information to the log buffer Optional.
Outputting system information to the SNMP module Optional.
Outputting system information to the Web interface Optional.
Configuring synchronous information output Optional.
Disabling a port from generating link up/down logging information Optional.
Outputting system information to the console
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable information center. info-center enable
Optional.
Enabled by default.
3. Name the channel with a
specified channel number.
info-center channel
channel-number name
channel-name
Optional.
See
Table 3 for default channel
names.