beautypg.com

Configuring the close-wait timer of the cpe, Displaying and maintaining cwmp – H3C Technologies H3C WX3000E Series Wireless Switches User Manual

Page 61

background image

52

To configure the maximum number of attempts that a CPE can make to retry a connection:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter CWMP view.

cwmp

N/A

3.

Configure the maximum
number of attempts that a CPE

can make to retry a

connection.

cwmp cpe connect retry times

Optional.
By default, the CPE regularly sends
connection requests to the ACS

until a connection is set up.

Configuring the close-wait timer of the CPE

The close-wait timeout is used mainly in the following cases:

During the establishment of a connection: If the CPE sends connection requests to the ACS, but the
CPE does not receive a response within the configured close-wait timeout, the CPE will consider the

connection failed.

After a connection is established: If there is no packet interaction between the CPE and ACS within

the configured close-wait timeout, the CPE will consider the connection invalid, and disconnect the
connection.

To configure the close wait timer of the CPE:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter CWMP view.

cwmp

N/A

3.

Configure the timeout value of

the CPE close-wait timer.

cwmp cpe wait timeout seconds

Optional.
The default is 30 seconds.

Displaying and maintaining CWMP

Task Command

Remarks

Display CWMP configuration.

display cwmp configuration [ |
{ begin | exclude | include }
regular-expression ]

Available in any view.

Display the current status of
CWMP.

display cwmp status [ | { begin |
exclude | include }

regular-expression ]

Available in any view.


This manual is related to the following products: