H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 73)

64
Outputting system information to the SNMP module
The SNMP module only receives trap information, and discards log and debug information.
To monitor the device running status, trap information is usually sent to the SNMP network management
system (NMS). For this purpose, you must configure output of traps to the SNMP module, and set the trap
sending parameters for the SNMP module. For more information about SNMP, see "SNMP
configuration."
To output system information to the SNMP module:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable the information center. info-center enable
Optional.
Enabled by default.
3. Name the channel with a
specified channel number.
info-center channel
channel-number name
channel-name
Optional.
See
Table 3 for default channel
names.
4. Configure the channel
through which system
information can be output to
the SNMP module.
info-center snmp channel
{ channel-number |
channel-name }
Optional.
By default, system information is
output to the SNMP module
through channel 5 (known as
snmpagent).
5. Configure a system formation
output rule for the SNMP
module.
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap
{ level severity | state state } * ] *
Optional.
See "
Default output rules of system
information ."
6. Configure the timestamp
format.
info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional.
The timestamp format for log, trap
and debugging information is date
by default.
Outputting system information to the Web interface
The Web interface only receives log information, and discards trap and debug information.
This feature allows you to control whether to output system information to the Web interface and, if so,
which system information can be output to the Web interface. The Web interface provides abundant
search and sorting functions. If you output system information to the Web interface, you can view the
system information by clicking corresponding tabs after logging in to the device through the Web
interface.
To output system information to the Web interface:
To set to output system information to the Web interface: