beautypg.com

Outputting system information to the trap buffer – H3C Technologies H3C WX3000E Series Wireless Switches User Manual

Page 71

background image

62

Step Command

Remarks

4.

Configure a system
information output rule for the

log host.

info-center source { module-name |
default } channel { channel-number

| channel-name } [ debug { level

severity | state state } * | log { level
severity | state state } * | trap

{ level severity | state state } * ] *

Optional.
See "

Default output rules of system

information

."

5.

Specify the source IP address
for the log information.

info-center loghost source
interface-type interface-number

Optional.
By default, the source IP address of
output log information is the

primary IP address of the matching

route' egress interface.

6.

Configure the timestamp
format for system information

output to a log host.

info-center timestamp loghost
{ date | iso | no-year-date |
none }

Optional.
date by default.

7.

Set the format of the system

information sent to a log host
to UNICOM.

info-center format unicom

Optional.
H3C by default.

8.

Specify a log host and
configure the related output

parameters.

info-center loghost
host-ipv4-address [ port

port-number ] [ channel
{ channel-number |

channel-name } | facility

local-number ] *

By default, the system does not
output information to a log host. If

you specify to output system

information to a log host, the
system uses channel 2 (loghost) by

default.
The value of the port-number
argument must be the same as the

value configured on the log host.
Otherwise, the log host cannot

receive system information.

Outputting system information to the trap buffer

The trap buffer only receives trap information, and discards log and debug information.
To output system information to the trap buffer:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enable the information center. info-center enable

Optional.
Enabled by default.

3.

Name the channel with a
specified channel number.

info-center channel
channel-number name

channel-name

Optional.
See

Table 3

for default channel

names.

This manual is related to the following products: