Configuring access-control rights, Configuration prerequisites, Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 28
19
Configuring the allowed maximum number of dynamic
sessions
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Configure the maximum
number of dynamic sessions
allowed to be established
locally.
ntp-service max-dynamic-sessions
number
The default is 100.
Configuring access-control rights
With the following command, you can configure the NTP service access-control right to the local device.
There are four access-control rights:
•
Query—Control query permitted. This level of right permits the peer devices to perform control
query to the NTP service on the local device but does not permit a peer device to synchronize its
clock to that of the local device. The so-called "control query" refers to query of some states of the
NTP service, including alarm information, authentication status, clock source information, and so
on.
•
Synchronization—Server access only. This level of right permits a peer device to synchronize its
clock to that of the local device but does not permit the peer devices to perform control query.
•
Server—Server access and query permitted. This level of right permits the peer devices to perform
synchronization and control query to the local device but does not permit the local device to
synchronize its clock to that of a peer device.
•
Peer—Full access. This level of right permits the peer devices to perform synchronization and control
query to the local device and also permits the local device to synchronize its clock to that of a peer
device.
From the highest NTP service access-control right to the lowest one are peer, server, synchronization,
and query. When a device receives an NTP request, it performs an access-control right match and uses
the first matched right.
Configuration prerequisites
Before you configure the NTP service access-control right to the local device, create and configure an
ACL associated with the access-control right. For more information about ACLs, see ACL and QoS
Configuration Guide.
Configuration procedure
To configure the NTP service access-control right to the local device:
Step Command
Remarks
1.
Enter system view.
system-view
N/A