beautypg.com

Configuration example, Network requirements, Configuration procedure – H3C Technologies H3C S6300 Series Switches User Manual

Page 88

background image

78

Step Command

Remarks

12.

Display traffic accounting
configuration.

display qos policy control-plane slot

slot-number

display qos policy global [ slot

slot-number ] [ inbound | outbound ]

display qos policy interface

[ interface-type interface-number ]
[ inbound | outbound ]

display qos vlan-policy { name

policy-name | vlan [ vlan-id ] } [ slot
slot-number ] [ inbound | outbound ]

Available in any view.

Configuration example

Network requirements

As shown in

Figure 22

, configure class-based accounting on Ten-GigabitEthernet 1/0/1 to collect

statistics for the incoming packets with 1.1.1.1/24 as the source IP address.

Figure 22 Network diagram

Configuration procedure

# Create basic ACL 2000, and configure a rule to match packets with source IP address 1.1.1.1.

system-view

[Device] acl number 2000

[Device-acl-basic-2000] rule permit source 1.1.1.1 0

[Device-acl-basic-2000] quit

# Create a traffic class named classifier_1, and use ACL 2000 as the match criterion in the traffic class.

[Device] traffic classifier classifier_1

[Device-classifier-classifier_1] if-match acl 2000

[Device-classifier-classifier_1] quit

# Create a traffic behavior named behavior_1, and configure the class-based accounting action.

[Device] traffic behavior behavior_1

[Device-behavior-behavior_1] accounting packet

[Device-behavior-behavior_1] quit

# Create a QoS policy named policy, and associate traffic class classifier_1 with traffic behavior
behavior_1 in the QoS policy.

[Device] qos policy policy

[Device-qospolicy-policy] classifier classifier_1 behavior behavior_1

[Device-qospolicy-policy] quit