beautypg.com

Configuration procedure, Network requirements – H3C Technologies H3C S6300 Series Switches User Manual

Page 39

background image

29

Figure 5 Network diagram

Configuration procedure

# Assign port priority to Ten-GigabitEthernet 1/0/1 and Ten-GigabitEthernet 1/0/2. Make sure that the
priority of Ten-GigabitEthernet 1/0/1 is higher than that of Ten-GigabitEthernet 1/0/2, and that no

trusted packet priority type is configured on Ten-GigabitEthernet 1/0/1 or Ten-GigabitEthernet 1/0/2.

system-view

[DeviceC] interface ten-gigabitethernet 1/0/1

[DeviceC-Ten-GigabitEthernet1/0/1] qos priority 3

[DeviceC-Ten-GigabitEthernet1/0/1] quit

[DeviceC] interface ten-gigabitethernet 1/0/2

[DeviceC-Ten-GigabitEthernet1/0/2] qos priority 1

[DeviceC-Ten-GigabitEthernet1/0/2] quit

Priority mapping table and priority marking
configuration example

Network requirements

As shown in

Figure 6

:

The marketing department connects to Ten-GigabitEthernet 1/0/1 of the device, which sets the
802.1p priority of traffic from the marketing department to 3.

The R&D department connects to Ten-GigabitEthernet 1/0/2 of Device, which sets the 802.1p
priority of traffic from the R&D department to 4.

The management department connects to Ten-GigabitEthernet 1/0/3 of Device, which sets the
802.1p priority of traffic from the management department to 5.

Configure port priority, 802.1p-to-local mapping table, and priority marking to implement the plan as
described in

Table 6

.

Internet

Device A

Device C

Server

Device B

XGE1/0/3

XG

E1/0

/1

XG

E1

/0/

2