Eneo iNEX Client - Manual (Page 94)

iNEX Standard
89
Chapter 8 — Event Handling
You can monitor video from a camera where an event is detected and play back event-recorded video.
Event related functions may not be supported depending on the protocol that the device uses (supported
for the iNEX protocol and some versions of the Axis protocol).
First, check the following and run the Client program.
 Services should be running on the system. Refer to 3.1 Running Services (p. 19) for details.
 Devices should be added to a device group. Refer to Chapter 13 — Device Management (p. 107)
for details.
 There should be recorded data in the allocated storage. Refer to 6.1 Setting up Recording Storage
(p. 65) for details.
 The event detection functions of the device should be enabled.
8.1 Handling a Monitoring Event
You can monitor live video from a camera where an event is detected or play back event-recorded video
if video of the selected event has been recorded.
The event list displays live and callback events from the registered devices. The
callback events are listed only when the remote callback function is set up in the
device.
You can change the options of the event list display during Menu – Preference
Settings. Refer to 4.3 Client, Menu – Preference Settings (p. 45) for details.
The description of event icons which are displayed in the event list is as follows
(some event icons may not be supported, depending on the specifications and version
of the device):
Motion Detection Video Blind Video Loss
Object Detection Audio Detection Video Analytics Detection
Trip-Zone Tampering Text-In
/ Alarm-In On/Off / Alarm-In Bad/Good / External Storage In/Out
/ Device Connected/Disconnected System Boot Up
System Alive System Restart System Shut Down
Recorder Bad Disk S.M.A.R.T. Disk Bad
Disk Full Disk Almost Full Disk Config Change
Disk Temperature / Panic Recording On/Off / Fan Error On/Off
Monitoring Video
Monitoring video from a camera where an event is detected is supported in the Live panel (maximum 4).
If a Live tab is not on the tab panel, go to the System menu, click New Tab and Live.