Eneo iNEX Client - Manual (Page 36)

iNEX Standard
31
Chapter 4 — System Overview
The iNEX software consists of the following programs:
 Service Manager: Controls the operation of services or displays system log. Refer to 4.1 Service Manager
(p. 31) for details.
 Setup: Allows you to add service, devices and users, or set up recording schedules, event management
schedules and storage. Refer to 4.2 Setup (p. 35) for details.
 Client: Allows you to monitor video from registered cameras, play back recorded video from storage,
export recorded video and check the system log and devices’ status. Refer to 4.3 Client (p. 40) for details.
NOTE: The following programs are provided apart from the iNEX program running (Go to the Start Menu →
Click iNEX and then Utility).
– ProblemReporter, SecretKey: You will use them following the directions of your dealer or distributor when
your dealer or distributor requests.
– Wibukey Tester: Use it to check information of the WIBU-Keys or whether or not the WIBU-Keys have any
problem.
– LanguageSelector: Use it to change the iNEX program’s language.
4.1 Service Manager
Services should be running on the system to operate the iNEX program. Go to
the Start Menu → Click iNEX → Run the Service Manager program.
Administration Server Recording / Streaming / Video Analytics Server
① Menu: Allows you to control the operation of the services or display the system log.
② Status Display: Displays the status of services.
Menu

Operation: Starts or stops all services. When the services are stopped, you cannot run the services and
Client program, and the system does not record. If you have changed any settings of the Service Manager
program, stop and restart all services to apply the changes.
 Option
− Server Option: Sets up the information for connection to the administration service from the current
server. Also, you can change the watchdog setting.