AEC Colortronic MS Series Screenless Granulator - Manual (Page 9)

Chapter 1 For safe use
- 4 -
[WO-3531;ET 4]
3. About labels
Labels are attached to this product at position where particular
attention is required by degree of danger. Before starting the operation
be sure to fully understand the instructions with the WARNINGs and
CAUTIONs.
Maintenance of the labels
● Keep the labels legible until you dispose of this unit.
● If the labels become dirty, wipe with the soft cloth that was soaked in water or hot water
under 40℃ and wring well. Do not use petroleum solvent and thinner in any case.
3-1. Contents of the labels
Caution of tip over
1. Caution of openning the cutting chamber of
guranulator.
2. Coution of the transfer and movement.
Don't tip over granulator for heavy weight.
Damage such as a fracture is suffered when it is
caught under the equipment.
◇
Support the feed hopper firmly, and open it
slowly when you open the openning cutting
chamber of guranulator.
◇
When moving guranulator, watch for crevices,
stairs, or grades on the floor to prevent
tipping. Then, be fully careful.