AEC Colortronic MS Series Screenless Granulator - Manual (Page 16)

Chapter 2 Precautions for use
- 11 -
[WO-3531;ET 11]
5. Precautions for maintenance check and parts exchange
Heading Item Precautions
DANGER
Cutting chamber of
guranulator Support the feed hopper firmly, and open it slowly when you
open the open cutting chamber of guranulator.
Don't tip over granulator for heavy weight.
Damage such as a fracture is suffered when it is caught under
the equipment.
WARNING
Feed hopper, cutting
chamber opens and
closes Be sure to lock wheels (caster×2) for the movement when feed
hopper, cutting chamber opens and closes.
Do not open the feed hopper and the cutting chamber of
granulator at same time.
In opened condition, don't touch a hand and lean on the feed
hopper.
Lift feed hopper slowly, and don't insert a hand, a finger into
pinch point imprudently when you close it.
Don't insert a hand into stopper of the hinge of feed hopper and
granulator when you open it.
When hand and fingers are inserted into pinch point, you suffer
the damage of lacerations and fracture.
WARNING
Put off the power
supply. Before maintenance checking and exchange, make sure to stop
operation and put “OFF“the primary power supply.
Then, avoid danger by incorrect operation.
WARNING
Rotating cutter Don't touch the cutter carelessly.
There are very sharp rotating cutter equiped inside, even without
power, your hands and fingers may get injured.