AEC Colortronic MS Series Screenless Granulator - Manual (Page 22)

Chapter 4 Installation
- 17 -
[WO-3531;ET 17]
DANGER
Step 4 working is dangerous. Therefore, perform to work with full-time
person.
Step Item Description
４ Confirmation of the
rotating cutter condition
Remove feed hopper clamp, and open feed hopper.
Confirm whether there is looseness in each fixed bolts of fixed cutter and guide
plate.
Remove axis cover on the reverse side of the motor.
Then, take the part of the width of 2 area of keeper plate with spanner or
monkey wrench, and confirm whether a shaft rotates smoothly.
Adjust the installation position of fixed cutter and guide plate when rotation
isn't smooth. (Refer to Chapter 7. Maintenance and check, 7-5 Exchange
point of the granulating cutters)
WARNING
◎ It is pushed down slowly with keep feed hopper from the down side
when feed hopper is opened.
Don't insert a hand and a finger into stopper.
When feed hopper is closed, it is lifted slowly.
At that time, be careful to insert a hand and a finger into pinch point.
When a hand and a finger are inserted into pinch point, it has the
danger of lacerations and fracture.
◎ Don't touch granulating cutter imprudently. Sharp granulating cutter
has the danger that a hand and a finger have lacerations.
５ Connection of the
power supply
Put off the primary power supply.
Connect the power cord of equipment with the primary power supply after you
confirm whether the switch of control box changes on the "STOP
position"("0"indicated) side.
◇
When the primary power supply is an outlet ;
Insert the power supply plug of equipment in the outlet.
Continue to the next page.