AEC Colortronic MS Series Screenless Granulator - Manual (Page 32)

Chapter 7 Maintenance and check
- 27 -
[WO-3531;ET 27]
5. Exchange point of the granulator cutters
Explains about the exchange work point of fixed cutter, guide plate and
rotating cutters (large and small) in order.
WARNING
Before exchange work, make sure to stop operation and put “ OFF“ the
primary power supply.
Then, avoid danger by incorrect operation.
5-1. Exchage of the fixed cutters and guide plate
Hopper is opened, and the exchange work is done.
Step Item Description
１
Openning the feed
hopper Remove the clamp of feed hopper, turns round the side the hopper
is fallen, and opens slowly.
WARNING
It is pushed down slowly with keep feed hopper from the
down side when feed hopper is opened.
Don't insert a hand and a finger into stopper.
When feed hopper is closed, feed hopper lifted slowly.
At that time, be careful to insert a hand and a finger into
pinch point.
When a hand and a finger are inserted into pinch point, it
has the danger of lacerations and fracture.
２
Exchang of the fixed
cutters and guide plate The fixed cutters and guide plate is removed and exchanged for the
new part. (refer to Fig. 7-1)
※
Refer to 5-3 how to gap adjust of rotating cutters and fixed
cutters of this chapter for the adjustment of the installation
position.
WARNING
Work carefully with wear the gloves, when touched the fixed
cutters and the guide plate.
For the sharp cutters, it has the danger that the hand and
the finger have the lacerations.