AEC Colortronic MS Series Screenless Granulator - Manual (Page 5)

Introduction
- Ⅳ -
[WO-3531;ET 4]
6. Improper or wrong maintenance, service, or handling; and
7. Your own transportation, repositioning, or reinstallation of our
products.
2)-C. Following is excluded from the warranty.
1. Any insufficient convey capacity, convey defect, weighing failure
resulting from property degeneration of the raw material.
2. Any clogging in pipe, convey defect, weighing failure resulting
from caking or cohesion of the raw material.
3. Lifetime of abrasion material such as hose or pipe is not
guaranteed.
4. Crystallization degree or moisture ratio (except for moisture ratio
for the resin tested and pre-confirmed and mutually recognized is
guaranteed.) is not guaranteed.
5. Failure/defect resulting from deformation and cohesion of resin.
6. Failure/defect resulting from any volatile additive yielded from
resin.
7. Failure/defect resulting from any condition that is not stated in
the
quotation.
3) Maintenance
Following inspection and maintenance must be performed in user’ s
responsibility and expense.
This warranty does not cover any product faulty due to omitting the
specified maintenance.
3)-A. Inspection for operation.
3)-B. Periodical inspection designated in the instruction manual or in the
catalogue.
3)-C. Periodical replacement of parts designated in the instruction
manual or in the catalogue.
3)-D. Replace consumable parts when expire.
3)-E. Inspect, supplement, replace, clean following items.
○ Oil, filter, sealing material, grease, bearing
○ Ventilation duct, Freon gas
○ Oil filter of air apparatus
○ Sedimentary deposits
○ Other related items
3)-F. Adjust following items
○ V belt
○ Chain
○ Temperature control apparatus
○ Valve for water supply or drain, etc.
○ Pneumatic apparatus for pressurized air
○ Over heating protection equipment, etc.