AEC Colortronic MS Series Screenless Granulator - Manual (Page 33)

Chapter 7 Maintenance and check
- 28 -
[WO-3531;ET 28]
5-2. Exchange of rotating cutters (large and small)
Feed Hopper is removed, and the exchange work is done.
Step Item Description
１
The removal of feed
hopper Pullout the clamp and hinge bilts of feed hopper, and remove the
feed hopper.
２
The removal of geared
motor The cutting chamber of granulator is lifted slowly, and released,
and the geared motor is removed.
３
Each part of overhaul
and exchange Loosen fixed nuts of the bearings at both ends of rotating axis, and
remove bolts.
With each rotating axis, pull up and remove the rotating cutters.
Stop ring⇒Collar⇒Bearing cover⇒Bearing⇒Side plate
(Labyrinth)⇒Small cutters⇒Large cutters
Pull out in order and exchange.
After exchange, assemble part reversely in order.
WARNING
The exchange work is doing carefully with wear the gloves.
For the sharp cutters, it has the danger that the hand and
the finger have the lacerations.