AEC Colortronic MS Series Screenless Granulator - Manual (Page 37)

Chapter 8 Troubleshooting
- 32 -
[WO-3531;ET 32]
The granulator doesn't start.
Check point Remedy Precaution
Check whether the feed hopper is
securely close.
And, check whether the different
material in the clamp part of feed
hopper isn't caught. Remove the different material.
And, tighten the clamp of feed
hopper securely. The granulator doesn't start under the
"OFF" condition of the limit switch for
closing confirmation.
Check whether the cutting
chamber is securely close.
And, check whether the different
material in the clamp part of
cutting chamber isn't caught. Remove the different material.
And, tighten the clamp of cutting
chamber securely. The granulator doesn't start under the
"OFF" condition of the limit switch for
closing confirmation.
Check whether the two each limit
switch is functioning normally. Do the repair of the switch or the
exchange. Refer to Chapter 7. Maintenance and
check, -2. Every three maintenance and
check.
To repair or exchange the limit switch,
please contact our service division.