Westermo TDW-33 - Manual (Page 46)

6618-3202 46
*WIOL – Generic I/O list
Supported by: TD-36 485 TR-36B
Description:
This command is used to program the list of I/O entries with parameters and data.
Syntax:
AT*WIOL = ,,,,,<”data1”>,<”data2”>,
, ,,
AT*WIOL = ? List all table entries. Listing will present a short form table of the
entire I/O list..
AT*WIOL=n? List all data parameters for a defined entry.
AT*WIOL?
Parameters:
I/O entry number, up to 10 entries can be defined.
I/O entry service
0 = NONE No service defined for this entry
1 = DIAL Makes a connection to the number defined in
2 = SMS Destination number of the SMS
SMS-message.
SMS service provider number
SMS protocol type (0 = NONE,1 = UCP,2 = TAP)
Password if required by provider.
3 = TEXT Make a connection to number defined in and transfer text
defined in .
4 = EMAIL Reserved for future use, service not implemented
5 = OUT Make a connection to the number defined in and set/pulse
the remote output according to pattern defined in string defined in
. The connection is terminated after the pattern is trans-
ferred.
6 = CMD AT command specified by is executed when the entry is
trigged
7 = TRANS Makes a connection to number defined by ,
I/O is transferred transparently between the two units. The trans-
parent mode must be ended by a timeout.