Westermo TDW-33 - Manual (Page 44)

6618-3202 44
*WI – Information string
Supported by: TDW-33 TD-36 TD-36 485 TR-36 TR-36B
Description
The command enable or disable the sending of an information string to the DTE or
remote DCE according to the parameter supplied. The parameter values, if valid, are
stored in the active profile.
Syntax:
AT*WI=<”string”>,
Parameters:
<”string”>
Information string [0-40 characters].
Information string mode [0-5].
0: Disable the function
1: Send information string to remote DCE when inactivity timer (S30) expires.
2: Send information string to remote DCE after connect message or DCD.
3: Send information string to DTE when inactivity timer (S30) expires.
4: Send information string to DTE after connect message or DCD.
5: Same as number 2 but with an extra CR.
Other values: “ERROR” string is sent back.
Command example Possible responses Note
AT* WI=”Info string 1”,1 OK Send info string to
remote DCE when
inactivity timer expires.
AT* WI =”Info string”,4 OK Send info string to DTE
when connected.
AT* WI =”” OK Delete info string and
disable function
(mode to 0)
AT*WI=,0 OK Disable function
AT*WI=,1 OK Enable function with
mode set to 1
AT* WI? *WI: string, mode List parameters
OK
AT* WI =? * WI : (0-40 CHAR), List command parameters
(0-255)
OK
ERROR Otherwise
S register: See S30