Visara eTerm 350 - Manual (Page 44)

4-2 707018-006
e Term 350 Windows-based Terminal
Through the Terminal Properties property sheet, you can perform the following
configuration tasks:
• Check hardware and software status of the terminal.
• Change the network configuration.
• Reset the terminal to standard factory defaults.
• Change attributes for the keyboard, mouse and display.
• Adjust the audio volume and sounds properties.
• Specify server for software updates.
• Add/configure a local-attached printer.
• Enable/configure security settings for Connection Manager and Terminal Properties.
• Configure Advanced Settings such as DHCP Options, Global ICA Settings and SNMP.
• Configure local browser settings (if applicable).
When you finish viewing or modifying configuration settings in the Terminal Properties
property sheet, do one of the following:
• Click Apply to apply changes you have made without closing the dialog box.
• Click OK to apply the changes and close the dialog Box.
• Click Cancel to close the dialog box without applying any changes.
Resetting Factory Defaults
The unit is provided with factory default configuration values, which can restore if the
unit has been configured to an unrecognizable setting.
Resetting the terminal values on this tab WILL remove the Connection Parameters
on the Terminal Connection Manager screen.
To reset terminal properties values but save the Connection Parameters, use the Load
Terminal Default Settings (Retain Connection Manager sessions) checkbox on the
Advanced tab. To return the configuration of the unit to the default values set at the
factory, complete the following steps:
• Press [F2] to display the Terminal Properties property sheet.
• Select the General tab.
• Check Load Terminal Default Settings at the bottom of the dialog box, then
click OK.