Visara eTerm 350 - Manual (Page 13)

707018-006 2-1
Chapter 2. e Term Setup Wizard
Configuring the Unit
The first time you power up the system, the Setup Wizard will lead you though the
configuration process. After the Setup Wizard is completed, it will not reappear unless
the terminal performs a flash recovery or the terminal is reset to factory defaults.
This section explains each screen of this unit’s Setup Wizard in sequential order. After
you finish the Setup Wizard, you can change any configuration setting through the
Terminal Properties property sheet. You can open this Terminal Properties dialog
box anywhere at anytime by pressing the [F2] key.
Welcome Screen
When the Welcome screen appears, click Next.
License Agreement Screen
The End User License Agreement specifies the legal terms governing your use of this
product. To proceed, click Accept.