Visara SCON-20L Reference Manual - Manual (Page 9)

707043-005 2-1
Chapter 2. Installation
Installation Checklist
The following is a brief checklist of typical installation tasks for the SCON-20L/22L.
Detailed information is provided later in this chapter.
1. Check the shipping carton for any obvious shipping damage prior to unpacking.
2. Unpack the Console Concentrator per instructions provided with the shipping carton.
This unit weighs approximately 50 lbs., so please take any necessary precautions
such as seeking help with lifting.
3. Place the Console Concentrator in an appropriate location. Refer to “Environmental
Parameters.”
4. Remove the cardboard protector (if present) from the disk drive. The unit should
not be powered on with a cardboard protector in the disk drive or the disk drive may
be damaged.
5. Inspect the unit for any physical damage.
6. Install (if required) and connect 3270 Coax, ESCON, Ethernet, and/or Token Ring
cables as needed.
7. Ensuring that the Power switch on the front of the Console Concentrator is off,
plug the Console Concentrator into an appropriate AC outlet.
8. Turn the Console Concentrator on (see Chapter 4, “Operation”). After a few seconds,
messages will appear on the LCD of the Operator Panel. These messages will change
as the unit proceeds through the various IML states until it has completed the boot
up procedure. When the boot has completed, the word ‘CONFIGURATION’ should
appear on the LCD. This initial boot process should take a few minutes (less than
10). If the boot process has not completed, or if you see a message that begins with
‘ERR’ or ‘XCP’, then a failure of the boot process has occurred. If a failure of the
boot process occurs, you will want to contact your Service Provider or the Visara
Intellicenter for assistance. Removal of the covers by unauthorized persons can
void your warranty.
9. Configure the Console Concentrator for use (see the SCON-20L/22L/25L/28L
Configuration Manual, SCON-20L/22L/25L/28L Installation Guide, and LINCS
Central Control manual).