Visara SCON-20L Reference Manual - Manual (Page 38)

5-4 707043-005
SCON-20L/22L Hardware Reference Manual
Replacement
1. Locate the correct slot in which the Circuit board is to be located.
2. Align the Circuit board onto its mounting track and slide the board into place.
Ensure the board connector is properly seated. For FET and ESC cards, ensure
that the daughter cards are properly seated into their sockets.
3. Replace and tighten the fastening screw(s) to the board bracket. If loosened,
realign and tighten the front board guide bracket.
4. Replace the covers and cables.
Power Supply Assembly
The Power Supply assembly is held in place by a single screw.
Removal
1. Ensure power is off. Remove the cover.
2. Locate and disconnect all cables attached to the Power Supply Cable assembly.
3. Remove the screw located at the front of the assembly.
4. Lift the assembly from its mounting.
Replacement
1. Align the assembly onto its mounting place.
2. Install the fastening screw.
3. Connect all cables to the assembly and replace the cover.
Operator Panel
The operator panel is attached to the Console Concentrator with plastic guides.
Removal
1. Ensure power is off. Remove the covers.
2. Disconnect the operator panel cable.
3. Lift the panel clear of its mounting bracket. Take care when flexing the plastic
tabs that hold the Operator Panel in place with the metal hardware. These
plastic tabs are easily broken.