Visara SCON-20L Reference Manual - Manual (Page 30)

4-6 707043-005
SCON-20L/22L Hardware Reference Manual
Exception Errors (XCP ___)
Exception errors are detected by a processor and occur during IML. Exception
errors are nonrecoverable and require recording the error information and then
IMLing the Console Concentrator to resume operation.
Exception error messages look like this on the operator panel:
XCP Jnn:bb:eee* where:
XCP indicates an exception error.
Jnn indicates the physical slot number of the board where the error occurred.
bb shows the board ID in hexadecimal format.
eee shows the type of exception error.
* indicates additional messages that give more information about the error (not
always present).
The LINCS Problem Determination manual contains additional information about
Exception errors.
If unable to correct the problem, prepare a dump disk of the error information, reference
LINCS Problem Determination manual/“Utility 20” and then call the next level of
technical support.
Exception errors are recorded into the box$fail.txt file.
Hardware Failures (FAIL ___)
Hardware failures show specific hardware problems. They may occur during IML
or testing mode. Code verification errors may also display as a hardware failure.
Error messages display on the operator panel as shown below:
Hardware - FAIL Jnn:bb:Tnn*
Code Verification - FAIL Jnn:bb:MOV* where:
FAIL indicates a hardware error.
Jnn is the slot number of the failing board.
bb shows the board type ID in hexadecimal format.
T is the failing test type.
nn is the failing test number.