Verilink WANsuite 5650 (34-00314.E) Product Manual - Manual (Page 59)

F r o n t P a n e l I n t e r f a c e 4-3
LED Indicators
The table below describe the WANsuite 5650’s front panel LED indicators.
NOTICE: The SHDSL , G.703 , and Nx64 port LEDs will flash when selected by
the port select button
Table 4.1 LED Indicators
LED Label Off Green Amber Red
POWER No Power Power applied to unit Unit in test mode.
SHDSL Mains Power Off Trained with good
signal quality Trained with marginal
signal quality Training or attempting
to train with poor
signal quality and/or a
major network port
alarm is active
G.703 Service not configured Service configured and
interface is operating
normally
Service is configured
and has minor alarms:
RAI; Slip Service configured and
interface is not
operating normally:
LOS; LOA; AIS.
Nx64 Service not configured Service configured and
interface is operating
normally
Service configured and
interface is not
operating normally or
port mismatch
RTS/C Nx64k service not
configured or RTS/C
control line is OFF "RTS" or "C" control
line (from DTE) is ON
RLSD/I Nx64k service not
configured or RLSD/I
control line is OFF "RLSD" or "I" control
line (from DTE) is ON
LLoop No loop present A local loop is active
on the selected
customer port A local loop is active on
the selected customer
port A local loop is active
on the SHDSL port
RLoop No loop present A remote loop is active
on the selected
customer port A remote loop is active
on the selected
customer port A remote loop is active
on the SHDSL port
BERT not applicable not applicable not applicable not applicable