Verilink WANsuite 5650 (34-00314.E) Product Manual - Manual (Page 19)

A b o u t t h e W A N s u i t e 5 6 5 0 1-7
Supervisory Port
The SUPERVISORY PORT is a DB-9 female DCE connector configured for 8
bits, no parity, and 1 stop bit. Bit rates are configured through the unit’s
VT100 interface. The Supervisory port speed can be set to 1200, 2400, 4800,
9600, 19200, 38400, 57600, or 115200 bps. The initial default rate of the
Supervisory port is 38400 bps.
On power-up, the Supervisory port sends out diagnostic messages at the bit
rate of 115.2 kbps until the supervisory service acquires the Supervisory port,
after which the port speed is changed to the setting in the Supervisory
interface screen.
NOTICE: For information on pinout assignments for this connector, refer to
"Supervisory Port Pin Assignments" on page A-8. See "Ordering
Information" on page A-6 for information on cables for this connector.
Serial Interface
The SERIAL INTERFACE located on the rear of the WANsuite 5650 is a multi-
protocol interface presented physically as a DB-25 connection. The protocols
supported by this interface are V.35, V.36, and X.21.
Cables that adapt the DB-25 interface to the 34-pin V.35 interface are
available. These cables are optional equipment and their part numbers are
listed in Ordering Information on page A-6. DB-25-to-DB-25 cables are also
available if your installation requires them. Refer to Ordering Information on
page A-6 for details. Pin assignments for the serial interface are also listed in
Appendix A, "Specifications" .
CAUTION: F C C ru les req u ire th a t in terco n n ectin g ca b les ca rryin g h ig h -sp ee d d a ta
b e a p p ro p ria tely sh ield ed to m in im ize ra d io freq u en cy in terferen ce.
G.703 Port
The G.703 port connection on the rear panel of the WANsuite 5650 is a
standard eight-pin modular jack with a receive signal level of -27 dB that
terminates as 120 ohms. To view the pinout assignments for these interfaces,
refer to G.703 Connector Pin Assignments on page A-8.
SHDSL Port
The SHDSL port connection on the rear panel of the WANsuite 5650 is a
standard eight-pin modular jack with a receive signal level of -24 dB that
terminates as 135 ohms. To view the pinout assignments for this interface,
refer to SHDSL Interface Pin Assignments on page A-8.