Teac HS-20 - Manual (Page 80)

80
TASCAM HS-20
10 – Internal settings
OPTIONS page
Make settings related to the pre-recording and auto marks on
this page.
PreREC Time
Turn this function ON or OFF and set the length of pre-recording
time.
(Default: OFF)
When PreREC Time is ON, the signal input during recording
standby is captured by the built-in memory for the set amount
of time, allowing a maximum of 5 seconds to be recorded before
recording is started manually.
To set the pre-recording time, touch the knob, and adjust the
value using the DATA dial.
Setting range: 1–5 seconds (default: 2 seconds)
Auto mark
Make settings related to auto marks.
o Audio Over:
Use this to add markers when the set audio level is
exceeded.
Use this to add markers when the set level is exceeded.
Turn this function ON or OFF and set the detection level.
(Default: OFF)
To set the detection level, touch the knob, and adjust the
value using the DATA dial.
Setting values: –0.20 dB (default), –0.17 dB, –0.13 dB,
–0.10 dB, –0.06 dB, –0.03 dB.
Range: -0.10 dB to -0.06 dB (default: -0.03 dB)
Settings made here are reflected in the Over Level
setting on the METER SETUP screen.
o Time Interval:
Use this to add marks at fixed time intervals. Turn this
function ON or OFF and set the time interval. (Default:
OFF)
To set the time, touch the knob, and adjust the value
using the DATA dial. The setting range is 1–10 minutes
(default: 5 minutes). (default value)
o Sync Unlock:
Use this to add a mark when synchronization with
the master clock is lost. Turn this function ON or OFF.
(Default: OFF)
o PRE/REC/END:
Marks can be added automatically at the pre-record
start, recording start and recording end points. Turn this
function ON or OFF.
(Default: OFF)
NOTE
An "audio over" occurs when the level exceeds the maximum
level (full scale) minus the value set by the user.
(In the example above, this would be when the level exceeds
the maximum level minus 0.20 dB.)
NOTE
The PRE/REC/END auto marks are only added to takes in
take mode. They do not appear on the timeline in timeline
mode.
NOTE
After an Audio Over or Sync Unlock auto mark has been
placed, the same type of mark will not be repeated until at
least 10 seconds has passed.
Playback settings (PLAY SETUP)
Make playback settings on this screen.
GENERAL page
Make various settings related to the playback mode on this
page.
Play Mode
Set how the playback of takes and entries is handled using
the following buttons. This setting affects all modes except
timeline mode.
One Take button:
(default)
Only the currently selected take or
entry is played back.
All Take button: All the takes in the currently loaded
folder or all the entries in the
playlist are played back.
Repeat Mode
Turn repeat playback ON and OFF (default). (Default: OFF)