Teac DR-680MKII - Manual (Page 54)

54
TASCAM DR-680MKII
11 – Troubleshooting
If you are having trouble with the operation of this unit,
please try the following before seeking repair. If these
measures do not solve the problem, please contact the
store where you bought the unit or a TASCAM Service
Center.
8 Power will not turn ON.
• Confirm that the batteries are not dead.
• Confirm that the batteries are installed with the correct
¥ /^ orientations.
• Confirm that the power plug of the AC adaptor
(GPE248-120200-Z) is connected securely.
8 The unit is not responding to operations.
• Is the button lock function ON?
8 SD card is not recognized.
• Confirm that the SD card is inserted securely.
8 Playback is not possible.
• If it is a WAV/BWF file, confirm that it is of a compatible
sampling frequency.
• If it is an MP3 file, confirm that it is of a compatible
bit-rate.
8 No sound is output from the built-in speaker
• Are headphones connected?
• Is the SPEAKER item set to OFF?
• Is the volume level of the headphones minimized?
8 No sound is output from the headphones
• Is the volume level of the headphones minimized?
8 No sound is output from the monitoring system
• Confirm that the monitoring system is connected
correctly.
• Is the volume level of the connected monitoring system
minimized?
• Is the output level of this unit minimized?
8 Recording is not possible.
• Reconfirm connections.
• Reconfirm the input settings.
• Check whether the recording level is too low.
• Confirm that the SD card is not full.
• Confirm that the maximum number of files or takes has
not been reached.
8 The recording level is low.
• Is the trim setting too low?
• Is the MIC GAIN set to LOW?
• Is the output level of a connected external device too
low?
8 The sound I am trying to record is distorted.
• Is the trim setting too high?
• Is the MIC GAIN set to HIGH?
8 I cannot erase a file.
• Confirm that the SD card is not write-protected.
• Are you trying to delete a file that has been set to
read-only on a computer?
8 Files on this device do not appear on a computer.
• Confirm that the USB port of the unit is connected with
the computer.
• Are you using a USB hub?
• Is the unit recording or in recording standby?