Super Systems 9200 - Manual (Page 7)

Model 9200 Programmable Dual-loop Controller
SSi Manual SERIES 9200 7 Programmable Dual-loop
Model 9200 Terminals Connections
Additional Features
The Operator Interface (touch screen) contains a removable compact Flash Card that can be used to
transfer data from the Model 9200 to a computer. This flash card acts like a removable hard drive,
however it is very small and contains no moving parts to make it very portable. It is located on the back of
the touch screen (see Flash Card & Flash Card Reader ).
Also included is a Utility Software CD that includes SSi’s Super Data (SD) Charting. SD Charting is a utility
program that can be loaded onto any Windows® based computer (operating Windows 98® or higher).
This software will allow the computer to read the data from the Model 9200, and allow it to be charted in a
manner that is similar to a strip chart recorder.
The Operator Interface is normally accessed via the touch-screen, however connections also exist that will
allow the operator to use a traditional mouse and keyboard to enter information.
Ethernet Connections
The Ethernet connection has three distinct uses. The first is should the Operator Interface fail, the Ethernet
connection allows a laptop to be connected to the Series 9200 DIN rail mounted unit. This connection can
act as a LIMITED FUNCTION “operator interface” until the Operator Interface can be repaired or replaced.
The laptop needs to be operating a WINDOWS 98® or higher with Internet Explorer. The default IP
address is 192.168.0.200. If you are experiencing problems please call 800-666-4330 and talk with our
computer communications personnel. The second use for the Ethernet port would be for communications to