Super Systems 9200 - Manual (Page 33)

Model 9200 Programmable Dual-loop Controller
SSi Manual SERIES 9200 33 Programmable Dual-loop
press Calibrate. Pressing the Calibrate key stores
the appropriate value. Pressing the Done will return
you to the User Calibration Screen.
Pressing the Next -> key displays the following
calibration screen:
Pressing the Edit button displays a numeric keypad
allowing you to change the Zero Output 2 value.
Measured at terminals 26(-) and 25(+) for this
step. After entering the new Zero Output value
you must press Calibrate. Pressing the Calibrate
key stores the appropriate value. Pressing the
Done will return you to the User Calibration
Screen.
Pressing the Next -> key displays the following
calibration screen:
Pressing the Edit button displays a numeric
keypad allowing you to change the Span Output 2
value. Measured at terminals 26(-) and 25(+) for
this step. After entering the new Span Output
value you must press Calibrate. Pressing the
Calibrate key stores the appropriate value.
Pressing the Done button will return you to the
User Calibration Screen.
Pressing the Next -> displays a screen that
indicates that the calibration process is complete.
Pressing the Done key at the bottom right of the
screen takes you back to the Configuration Menu.
Full Calibration
Used by SSi personnel.
Set Menu Security
Pressing the Enter key moves you to the screen below.
Highlighting a specific screen (using the blue up and
down arrows) and pressing the Enter key changes the
displayed Security Level of the highlighted screen.
The additional items on the above screen are as follows:
Zone /Load TC Setup Supervisor
Port Setup Administrator
Instrument Setup Administrator
Zone Assignments Administrator
Furnace Setup Administrator
Default Wait Limits Administrator
Furnace Name Administrator
Alarm Setup Administrator
Edit
Span Output 1
Calibrate
<-- Back Skip Next --> DONE
Entered measured output current (mA)
Edit
Zero Output 2
Calibrate
<-- Back Skip Next --> DONE
Enter zero output current (mA)
Edit
Span Output 2
Calibrate
<-- Back Skip Next --> DONE
Enter measured output current (mA)