Super Systems 9200 - Manual (Page 37)

Model 9200 Programmable Dual-loop Controller
SSi Manual SERIES 9200 37 Programmable Dual-loop
on the screen without decimal points. For
example, an offset of 255 would actually
be an offset of 25.5 degrees +, and an
offset of –85 would be an offset of 8.5
degrees -.
Aux SP Configuration
This menu option allows for up to three slave
instruments to have the setpoint retransmitted
from one of the three control loops. This menu
option is typically used to retransmit an alarm
setpoint value to an overtemp controller.
The “Retrans to Slave 1”, “Retrans to Slave 2”,
and “Retrans to Slave 3” menu options each
have four options to select: Off, Loop 1, Loop
2, or Loop 3. These options will allow the user
to select which, if any, values to retransmit to
the selected slave instrument.
The “Setpoint Offset Sl 1”, “Setpoint Offset Sl 2”,
and “Setpoint Offset Sl 3” menu options can be a
number between –32767 and 32767. These
options will allow the user to set the destination
offset for the selected slave instrument.
The “Setpoint Delay Sl 1”, “Setpoint Delay Sl 2”, and “Setpoint Delay Sl 3” menu options can be a number
between –32767 and 32767. These options will allow the user to set the delay, in seconds, before the
setpoint is retransmitted to the selected slave instrument.