Super Systems 9200 - Manual (Page 29)

Model 9200 Programmable Dual-loop Controller
SSi Manual SERIES 9200 29 Programmable Dual-loop
IP Address 4 200
IP Address Mask 1 255
IP Address Mask 2 255
IP Address Mask 3 255
IP Address Mask 4 0
IP Address Gateway 1 192
IP Address Gateway 2 168
IP Address Gateway 3 1
IP Address Gateway 4 1
Highlighting whichever parameter needs to be entered and pressing the Enter key displays a numeric
keypad that can be used to enter the required value. Pressing the Esc key returns you to the Configuration
Menu.
The default IP Address is: 192.168.0.200
The default IP Address Gateway is: 192.168.1.1
Event Control
Pressing the Enter key makes the following screen appear.
Hold Instrument Number defines the Slave
Instrument to be placed in hold (normally used with
Soak) if the Process Variable goes below the value
entered in Hold Minimum PV , or above Hold
Maximum PV .
Highlighting your choice to be changed and pressing
the Enter key moves you to a numeric keypad that
allows you to enter a new value by touching the
appropriate keys. Once you have made the change
pressing the Enter key takes you back to the
previous screen. Once again pressing the Esc key
takes you back to the Event Control Screen without
making the changes.
Event for Program Run defines which event contact will start the program identified on the Event Run
Program Setup Screen.
Event for Program Reset defines which event contact will reset the program currently running.
NOTE: this will only reset the program, all set points, events, etc will remain in their last state.
Valve Setup – USED ONLY IN THE NITRIDING VERSION
Pressing the Enter key makes the following screen appear.