Super Systems 9200 - Manual (Page 12)

Model 9200 Programmable Dual-loop Controller
SSi Manual SERIES 9200 12 Programmable Dual-loop
Pressing the Login key takes you to the numeric keypad Enter Password Screen. Entering the correct
password (the default password is “2”) displays the Supervisor Menu, which includes the entire list of
menus necessary to configure the Series 9200. These are explained in detail in Chapter 2 – Configuration .
Program Display
Pressing the Program key displays the default Program Status page.
The Program Status Display shows the last
program loaded into the program run buffer
and its status. If the program is running,
the active step number is highlighted, and
the status is running. A red ALM block in
the top right corner of the screen displays
an alarm condition.
The Program Display has seven active
buttons located on the right side of the
display. Touching the inside of the blocks
activates these. The active buttons are
Soak Adjust, Load, Stop, Hold, Cont,
Alm Ack (Alarm Acknowledge) and Esc.
• The Soak Adjust button allows
you to enter a new value for the
time remaining in the current
soak or ramp cycle. A soak or
ramp cycle must be running for
a change in soak/ramp time to be adjusted.
• The Load button allows the operator to enter the recipe number to be run and to view the
recipe before pushing the Run button. Pushing the Run button starts the recipe. If a recipe
program is running and the operator enters a new recipe program it can be viewed and
modified. The recipe does not become active until the Run button is pushed. Pressing Run
places the program currently being viewed in the active memory and will begin to run the new
recipe. You can start the program in any step, simply by moving the highlight down to the step
that that the program needs to be started in, and then pressing the Run key.
While reviewing the program that is about to be run, certain parameters within those steps can
be modified. You can change the set points, the time and the options. You CAN NOT delete a
step, or modify it’s OPT CODE.
• The Stop button stops the recipe program that is currently displayed. Stop means exactly that!
It stops the program. It is NOT a hold button. See hold below. To re-start the program if it has
been stopped you must use the Load button, enter the recipe number, and then highlight the
segment number of the recipe that you want to start with and initiate Run .
• The Hold button places the displayed recipe program in hold. Once a decision is made that
affects the recipe, it may be continued by pressing the Cont button.
• The Cont button re-starts the displayed (active) recipe, where it was placed in hold at.
• The Alm Ack displays the Alarm Screen. From here you can acknowledge the alarm, in most
cases it will be acknowledging end of soak . The alarm must be acknowledged to allow the
program to go to the next step.
• The Esc button returns you to the default Display Screen.