Super Systems 9200 - Manual (Page 11)

Model 9200 Programmable Dual-loop Controller
SSi Manual SERIES 9200 11 Programmable Dual-loop
The remaining items on the Menu Display are:
• Instrument Setup
• Zone Assignments
• Furnace Setup
• Default Wait Limits
• Furnace Name
• Alarm Setup
• Relay Assignments
• Relay Setpoints
• Input Setup
• Output Setup
• Passcode and Alarm
• IP Address
• Event Control
• Valve Setup
• Valve Inputs
• Programmer Setup
• Recipe Transfer
• User Calibration
• Full Calibration
• Set Menu Security
• Read/Write Raw Data
• Tuning Assistant
• Curve Entry
• Alternate PID Setup
• Analog Input Board Setup
• AI Board Calibration
• ADAM Correction
• Aux SP Configuration
Menus
There are three levels of menus in the Series 9200.
• The first level is the
operator level . These are functions or operations that are typically
handled by the furnace operator. This menu is accessed without the need for a pass code.
• The second level is to be used by a supervisor . This level requires the entry of a level 1 or
level 2-pass code.
• The third level is the configuration level . This requires the level 2-pass code ONLY.
As shipped, the level 1 and level 2 codes are set as 1 and 2 respectively. The pass codes can be changed
at the Passcode and Alarm Screen
.
The menu has five operating buttons located on the right side of the screen. The UP arrow moves the
cursor from bottom to top. The Enter button activates the selection that the operator has chosen, the
DOWN arrow key moves the cursor from top to bottom, the Login key activates another screen that allows
access to the Supervisor Menu and the Configuration Menu, and the Esc key takes you back to the
previous screen without any action being taken.