Super Systems 9200 - Manual (Page 15)

Model 9200 Programmable Dual-loop Controller
SSi Manual SERIES 9200 15 Programmable Dual-loop
Chapter 2 - CONFIGURATION
Configuration Menu
The Configuration Menu is entered through the Menu
key that is part of the 7 buttons running down the
right side of the Default Display Screen. Pressing the
Login key that is below the blue up and down arrow
keys displays a numeric keypad. Enter the correct
passcode for the configuration level and press the
Enter key. This displays the following configuration
options:
Program Edit
Selecting this Program Edit button pops up another screen which asks the operator to enter a program
number to be edited. Enter 0 to edit a blank program. To ERASE/DELETE an existing recipe/program you
need to SAVE it as program Zero (0). Program 0 is a NO-OPT program.
When you enter a number for a stored program and push the Enter key the program steps are displayed.
Using the up and down arrow keys you select the step in the existing program that you wish to edit. Move
the cursor to that step and press the Enter key. The next screen to pop up will show the step’s parameter
and it’s value.
NOTE: A list of OPCODES appears in the Appendix of this manual.
Example:
Parameter equals OPCODE, Value equals SOAK.
Parameter equals TIME, Value equals 3:45.
Highlighting the opcode and soak and pressing the Enter key brings up a screen that shows all of the
possible opcodes. Selecting the opcode that you want to use for the program step that you are editing and
pressing the Enter key.
If you desire to change the time highlight the time and press the Enter key. The next screen is the Time
Edit Screen. To change the hour, press the Hour key in the upper right-hand corner. If you want to change
the minutes press the Min key. The next screen that pops up in both cases is a numeric keypad. Enter the
time that you wish to permanently change the recipe to and press the Enter key. If you DO NOT wish to
make any changes press the Esc key. Note, if you wish to only change the minutes, you must enter the
desired hour(s), if other than 0.
If you have made a change, pressing the Enter key takes you back to the Time Edit Screen. If you wish to
make the change, press the Set key on the right-hand side of the screen. The next screen to pop up
verifies the time has been changed to the number of minutes that you have selected. Pressing the Cancel
key takes you back to the full Program Screen. If you are sure that you want the change to be permanent
press the Set key. This takes you back to the screen that shows you the entire program. Notice that the
time has been changed on the program segment that you were editing. If you wish to save this change
press the Save key. You will notice that a numeric keypad pops up and asks you to enter the number of