Seaward Supernova - Manual (Page 78)

Downloading to Computer Software
68
Storing Appliance Test Results in Manual mode
The Appliance Test Results will not be stored until a Manual
Appliance Sequence has been completed. To do this firstly press A,
this will prompt you for an Appliance number, enter this and press
GREEN BUTTON twice. Perform the tests required then press C,
this will prompt you to enter comments, select SAVE
COMMENTS/RESULTS and press GREEN BUTTON. The unit will
then display the messages STORING RESULTS then SAVED OK.
Your results have now been stored.
Storing System Data
System Data consists of everything changed from within the SETUP
MENU. To store the System Data return to the MAIN MENU from the
SETUP MENU. The unit will then display the message STORING
SYSTEM DATA. This will only be done if changes have been made, if
no cahnges have been made then the system data will not be
updated.
Waiting for a Yes/No response
When you are prompted to respond with YES or NO you must use
the fastkeys under the display.
Using Symbols in Text Fields
Although there is an option to use non-ascii symbols as Appliance
numbers, Site & Location descriptions, User names and comments
does not guarntee that your computer software will support them. If
you are unsure avoid using symbols.
10 Digit Restriction
When you first receive your Supernova the Appliance and Comments
will be set to ‘10 Digit Restriction’. If you are using compatible
software then this option can be set to ‘Full Length’. When set to ‘Full
Length’ the maximum Appliance length is extended to 15 characters
while the maximum line for the comments is extended to 20
characters per line.