Seaward Supernova User Manual
Page 45
How to perform Manual Tests
35
highlight LOCATION and press Enter to change the Site Name
Use the cursor keys to highlight a Location name and press Enter to
select the desired option.
Note
Default settings for Sites and Test Sequences are pre-loaded
into the Tester. See ‘How to use Setup’ to change these
settings.
Change Output Socket
Press the S key to toggle between 230V and 115V output sockets.
The LED indicators on the Top Panel indicate which socket is active.
You may need to use the adaptor when changing voltages
Use the keyboard to enter comments into the box (4 lines of 20
characters). Press Enter for a new line. To store the comments press
the OK fastkey. Use the Red button if you do not want to store the
comments.
Select Manual Test
Use the appropriate number key from the table to select a specific
test or use the cursor to highlight the desired option.
Performing a Manual Test
After selecting the appropriate test the tester displays a screen from
which you can set test paramteres.
The user can change an individual setting when the icon is shown
inverted. Use the left and right cursor keys to highlight a field on the
display. Then use the up & down cursor keys to change the variable
in the selected field.
When an icon is shown inverted use the left and right cursor keys to
highlight a field on the display. Then use the up and down cursor
keys to change the variable in the selected field.