Seaward Supernova - Manual (Page 63)

How to use the Memory
53
User List
This allows the user to password protect the User List. An existing
password must be setup before the option can be used.
Aplnce & Cmnts
This allows the user to limit the Appliance number and Comment
lines to 10 digits. When limited to 10 digits the Supernova can be
downloaded to a wider range of software.
Change Password
It is possible to Password protect the Test Sequence Editor and the
Country Settings.
If you currently do not have password protection you will be asked to
enter a new password twice, once for confirmation.
If you currently do have password protection then you will be asked
for the old password before entering a new one, again you will be
asked for the new password twice.
To clear the password protection simply press Enter when asked for
the new password. A warning will show that no password is in place.
Set Brightness
You can now set the Brightness of the display. Use the cursor keys to
change the Brightness, once the Brightness is set press the Green
button to accept the changes. Press the Red button to abort any
changes made.
Factory Settings
It is possible to reset the Supernova to the settings which were
configured from new. This option will first ask you if you are sure,
select Yes to reset or No to abort.
How to use the Memory
To use the memory tests and functions, use the cursor keys to
highlight the Memory Options option on the Main Menu and press
Enter to display the following menu:-