Seaward Supernova - Manual (Page 31)

How to perform Automatic Tests
21
Note
Help screens may be displayed depending on the User Level
set. It is possible to stop these appearing by altering the User
Level. See EDIT USER LIST OPTIONS. Help can be
displayed during any test by pressing the appropriately
marked fast key.
If an Insulation test has been selected, then once the test has
commenced, a screen similar to the following will be displayed:-
If an external connection e.g. a probe is required, the display will flash
the connection icon. The user needs to connect the probe. The test
can then proceed when the GREEN BUTTON button is pressed. At
the end of each test in the test sequence, the display will indicate the
result.
All test results are automatically stored.
If any test in the test sequence fails, then the test sequence is
aborted and an fail message will be displayed. A Failure Menu may
be shown if the option is selected (see Test Options.)