REMKO EFS 25-35 - Manual (Page 23)

4.5 Information messages
Display Description
Flashes
The sliding domestic hot water tem-
perature is active.
5 Assembly and
dismantling
NOTICE!
The following section only describes the instal-
lation of the controller. When installing external
components (valves etc.), follow the instruc-
tions provided by the relevant manufacturer.
Opening/closing the housing
Remove the front panel
n Grasp the front panel 1 by the grip grooves on
the side 2 and pull it forwards 3 (Fig. 27).
2 2
1 3
5
4
Fig. 27: Remove the front panel
1: Front panel
2: Grip grooves
3: Pull front panel forwards
4: Screw
5: Terminal cover
Attach the front cover
n Position the front panel 1 carefully and press it
onto the housing so that it clicks into place.
23