REMKO EFS 25-35 - Manual (Page 18)

Temperature control
If a function is to be controlled by temperature, the
temperature control must be switched on (tc = tem-
perature control). In the Fig. 12, the temperature
control is activated ("on").
Fig. 12: Key variable for temperature control
Clock control
If a function is to be controlled by time, the clock
control must be switched on and the time window
set (cc = clock control). In the Fig. 13, the clock
control is activated ("on").
Fig. 13: Key variable of clock control
Start time of a time window
When setting the start time of a time window, the
following is displayed to the left of the start time
(see Fig. 14):
n
n
Number of time window 1 ... 3, its start time
was set (here: 1)
n "on"
Fig. 14: Key variable of time window start
End time of a time window
When setting the end time of a time window, the
following is displayed to the left of the end time
(see Fig. 15):
n
n
Number of time window 1 ... 3, its end time was
set (here: 1)
n "off"
Fig. 15: Key variable of time window end
The start time is always before the end time! If
you attempt to set the start time to later than
the end time, the end time is automatically
pushed back.
REMKO fresh water station Controller
18