REMKO EFS 25-35 - Manual (Page 15)

Operation
√ The controller is in the status display.
You can display and reset the saved minimum/
maximum/difference values as follows:
1. If necessary, press "r s" to display a dif-
ferent component 4 , component flashes).
2. Press "SET". The minimum/maximum/differ-
ence values are displayed alternately 5 .
3. If necessary, press "SET" for 2 seconds to
reset the value that is currently (!) displayed
6 .
4. Press "ESC". The status display is displayed.
5. Repeat steps 1 to 4 if required.
You can display the status of external compo-
nents as follows:
Press "r s" to display the status of a different
component ( 4 ).
You can call the setting menu as follows:
Press "SET" for 2 seconds 7 . The setting menu is
displayed.
7
7
7
7
6
6
6
6
Fig. 8: Automatic operating mode - operation
4.3 Setting menu
Overview
The diagram below provides an overview of the
structure of the setting menu.
Domestic hot water
target temp.
 Time
SET
the time
Setting
Functions
SET
Heat content
F:01

Thermal
disinfection

Factory setting

Circulation
F:02

SET
5 Sek.
Reset to factory
setting
Distrib. valve in
return flow- F:03

Comfort
function F:04

Bypass
F:05

Follow-up
F:06

Sliding hot water
temp. .- F:07


Thermal
disinfection F :08
Cascade
F:09

Call the setting menu and select the menu
entry
√ "Automatic" or "Off" operating mode is selected.
1. Press "SET" for two seconds. The setting
menu is displayed, the menu entry flashes.
2. Press "r s" to select a different menu entry.
3. Change the settings as described in the fol-
lowing sections.
15