beautypg.com

REMKO EFS 25-35 User Manual

Page 19

background image

Flow control

If a function is to be controlled by flow, the flow

control must be switched on (Fc = flow control). In

the Fig. 16, the flow control is activated ("on").

Fig. 16: Key variable of flow control

Speed control for the circulation pump

If a function is to be controlled by speed, the speed

of the circulation pump must be set.

Fig. 17: Key variable for speed control of pump

Function descriptions

The tables in this section describe the key variables of the functions as follows:

n

The rows contain the key variables in the same sequence as they appear on the display.

n

The columns contain the following information from left to right:

Column

Description

Display

Example for the display when setting the key variables.

Key variable

Descriptions of the key variables and their dependencies to each other. Dependent key

variables can only be selected and set of the higher-level key variable has the value

"on". This is displayed as follows:

n

Higher-level key variable: Bold font

n

Dependent key variables: Below the higher-level key variable and indented to the

right

Example: In the table of the circulation function, the probe input, switch-on temperature

and switch-off temperature key variables are only displayed if the temperature control

has the value "on".

minimum, max-

imum, factory

setting

The lower (minimum) and upper (maximum) limits of the value range of a key variable,

as well as the factory setting. If a value range only contains a few values, these are

specified individually. Example: "on", "oFF".

Heat content

Calculates the heat content determined using the

following key variables:

n

Hot water temperature, secondary

n

Cold water temperature, secondary

n

Medium flow rate, secondary

No further settings are required. The function can

only be activated or deactivated.

Fig. 18: Calculating heat content

Measured value display: The measured values

are displayed in the status menu. The current per-

formance and the daily heat content are displayed

after the fresh water values.

19