REMKO EFS 25-35 - Manual (Page 14)

You can display the current temperature and
operating hours as follows:
1. Press "ESC". The temperature/operating
hours value is displayed, the corresponding
component flashes ( 3 ), the display is not
shown).
2. Press "r s" to select a different component.
3. Press "SET" to exit the display of the temper-
ature/operating hours value.
2
3
Fig. 7: Manual operating mode - operation
Automatic operating mode
Method of operation
Automatic operating mode is pre-set in the deliv-
ered state. Automatic is the normal operating
mode, the system is controlled automatically. The
following actions are possible:
n Display status (status display): Display status
of external components (temperatures, switch
statuses, running times) 4
n Display the saved minimum and maximum
values (temperature probe) or the cumulative/
difference values (operating hours
1) of the
pumps and valves) 5
Cumulative values (Σ symbol): Operating hours
since initial commissioning. Cumulative values
cannot be reset.
Difference values (Δ symbol): Operating hours
since the last reset to 0
n Reset the saved minimum/maximum/difference
values 6
n Call the setting menu 7
1) Cumulative switch on times for the outputs
REMKO fresh water station Controller
14