REMKO EFS 25-35 - Manual (Page 12)

4 Operation
4.1 Buttons and Display
This section contains general information about
operating the controller.
Buttons
Operation takes place using the r, s, SET, ESC
and buttons as follows:
r • Scrolls up in the menu
• Increases the setting value by 1 level)
s • Scrolls down in the menu
• Reduces the set value by 1 level
SET • Selects a set value to be changed
(setting value flashes)
• Confirms a set value or moves down
one menu level
• Calls the set menu (not in manual
mode
ESC • Discards a setting
• Moves up one operating level
Sets the operating mode
We recommend noting changed settings in
writing.
Display during operation
n A component flashing in the system diagram
means the following: The operating value or
setting value that is displayed applies to the
flashing components. Exception: It
always flashes in manual mode.
n Displays that are automatically alternating are
shown overlapping in the figures. Example:
Fig. 6.
4.2 Operating modes
Change operating mode
NOTICE!
Danger of damage to the pump due to dry run-
ning. Switch on the manual and automatic
operating modes only if the system is filled.
1. Remove the front panel.
2. Press the button for 2 seconds to
change the operating mode.
3. Repeat step 2 if required.
4. Attach the front cover.
2 1 3
Fig. 5: Change operating mode
1: Off
2: Manual mode
3: Automatic
REMKO fresh water station Controller
12