Example #5: specify mac acl attributes – D-Link UNIFIED WIRED & WIRELESS ACCESS SYSTEM DWS-3000 User Manual
Page 99
MAC ACL CLI Examples
99
16 Access Control Lists (ACLs)
Example #5: Specify MAC ACL Attributes
(DWS-3024) (Config)#mac access-list extended mac1
(DWS-3024) (Config-mac-access-list)#deny ?
any Configure a match condition for all the source MAC
addresses in the Source MAC Address field.
(DWS-3024) (Config-mac-access-list)#deny any ?
any Configure a match condition for all the destination
MAC addresses in the Destination MAC Address field.
bpdu Match on any BPDU destination MAC Address.
(DWS-3024) (Config-mac-access-list)#deny any 00:11:22:33:44:55 ?
(DWS-3024) (Config-mac-access-list)#deny any 00:11:22:33:44:55 00
:00:00:00:FF:FF ?
Ethertype (appletalk, arp, ibmsna, ipv4, ipv6, ipx,
mplsmcast, mplsucast, netbios, novell, pppoe, rarp).
<0x0600-0xffff> Enter a four-digit hexadecimal number in the range of
0x0600 to 0xffff to specify a custom Ethertype value.
vlan Configure a match condition based on a VLAN ID.
cos Configure a match condition based on a COS value.
log Configure logging for this access list rule.
assign-queue Configure the Queue Id assignment attribute.
(DWS-3024) (Config-mac-access-list)#deny any 00:11:22:33:44:55 00:00:00:00:FF:FF log ?
assign-queue Configure the Queue Id assignment attribute.
(DWS-3024) (Config-mac-access-list)#deny any 00:11:22:33:44:55 00:00:00:00:FF:FF log
(DWS-3024) (Config-mac-access-list)#exit
(DWS-3024) (Config)#exit
(DWS-3024) #