D-Link UNIFIED WIRED & WIRELESS ACCESS SYSTEM DWS-3000 - Manual (Page 146)

146 © 2001- 2008 D-Link Corporation. All Rights Reserved.
Wired Configuration Guide
CLI Examples
The commands shown below show examples of configuring DHCP Filtering for the switch
and for individual interfaces.
Example #1: Enable DHCP Filtering for the Switch
This example
config
ip dhcp filtering
exit
exit
Example #2: Enable DHCP Filtering for an Interface
config
interface 0/11
ip dhcp filtering trust
exit
exit
Example #3: Show DHCP Filtering Configuration
show ip dhcp filtering
Switch DHCP Filtering is Enabled
Interface Trusted
--------- -----------
0/1 No
0/2 No
0/3 No
0/4 No
0/5 No
0/6 No
0/7 No
0/8 No
0/9 No
0/10 No
0/11 Yes
0/12 No
0/13 No
0/14 No
0/15 No
Web Examples
From the Web interface, you can perform the following DHCP Filtering tasks:
• Enable or disable administration mode on the switch
• Enable or disable the DHCP Filtering trust mode on specific interfaces
• View the interface binding information for DHCP Filtering