Example #3: show sntp server, Example #4: configure sntp, Example #5: configure sntp client mode – D-Link UNIFIED WIRED & WIRELESS ACCESS SYSTEM DWS-3000 User Manual
Page 162
162
© 2001- 2008 D-Link Corporation. All Rights Reserved.
Wired Configuration Guide
Example #3: show sntp server
(DWS-3024) #show sntp server
Server IP Address:
81.169.155.234
Server Type:
ipv4
Server Stratum:
3
Server Reference Id:
NTP Srv: 212.186.110.32
Server Mode:
Server
Server Maximum Entries:
3
Server Current Entries:
1
SNTP Servers
------------
IP Address:
81.169.155.234
Address Type:
IPV4
Priority:
1
Version:
4
Port:
123
Last Update Time:
MAY 18 04:59:13 2005
Last Attempt Time:
MAY 18 11:59:33 2005
Last Update Status:
Other
Total Unicast Requests:
1111
Failed Unicast Requests:
361
Example #4: configure sntp
(DWS-3024)(Config) #sntp ?
broadcast
Configure SNTP client broadcast parameters.
client
Configure the SNTP client parameters.
server
Configure SNTP server parameters.
unicast
Configure SNTP client unicast parameters.
Example #5: configure sntp client mode
(DWS-3024) (Config) #sntp client mode broadcast ?
Press Enter to execute the command.
(DWS-3024) (Config) #sntp client mode unicast ?
Press Enter to execute the command.
(DWS-3024)(Config)#sntp broadcast client poll-interval ?
<6-10>
Enter value in the range (6 to 10). Poll
interval is 2^(value) in seconds.