D-Link UNIFIED WIRED & WIRELESS ACCESS SYSTEM DWS-3000 - Manual (Page 52)

52 © 2001- 2008 D-Link Corporation. All Rights Reserved.
Wired Configuration Guide
Example #2: show mac-address-table igmpsnooping
(DWS-3024) #show mac-address-table igmpsnooping ?
Press Enter to execute the command.
(DWS-3024) #show mac-address-table igmpsnooping
MAC Address Type Description Interfaces
----------------------- ------- ------------ -----------
00:01:01:00:5E:00:01:16 Dynamic Network Assist Fwd: 0/47
00:01:01:00:5E:00:01:18 Dynamic Network Assist Fwd: 0/47
00:01:01:00:5E:37:96:D0 Dynamic Network Assist Fwd: 0/47
00:01:01:00:5E:7F:FF:FA Dynamic Network Assist Fwd: 0/47
00:01:01:00:5E:7F:FF:FE Dynamic Network Assist Fwd: 0/47
Example #3: set igmp (Global Config Mode)
(DWS-3026) (Config)#set igmp ?
Press enter to execute the command.
groupmembership-interval Configure IGMP Group Membership Interval
(secs).
interfacemode Enable/Disable IGMP Snooping.
maxresponse Configure IGMP Max Response time (secs).
mcrtrexpiretime Sets the Multicast Router Present Expiration
time on the system.
(DWS-3026) (Config)#set igmp
Example #4: set igmp (Interface Config Mode)
(DWS-3026) (Config)#interface 0/2
(DWS-3026) (Interface 0/2)#set igmp ?
Press enter to execute the command.
fast-leave Enable/Disable Fast-Leave on a selected
interface
groupmembership-interval Configure IGMP Group Membership Interval
(secs).
maxresponse Configure IGMP Max Response time (secs).
mcrtrexpiretime Sets the Multicast Router Present Expiration
time on
the system.
mrouter Configure Multicast Router port.
(DWS-3026) (Interface 0/2)#set igmp