Command buttons – D-Link UNIFIED WIRED & WIRELESS ACCESS SYSTEM DWS-3000 User Manual

Page 30

Wired Configuration Guide

2. Using the User pull-down menu, select Create to create a new user.

3. Enter a new user name in the User Name field.

4. Enter a new user password in the Password field and then retype it in the Confirm

Password field.

NOTE: If SNMPv3 Authentication is to be implemented for this user, set a password

of eight or more alphanumeric characters.

5. If you do not need authentication, go to Step 9.

6. To enable authentication, use the Authentication Protocol pull-down menu to select

either MD5 or SHA for the authentication protocol.

7. If you do not need encryption, go to Step 9.

8. To enable encryption, use the Encryption Protocol pull-down menu to select DES for the

encryption scheme. Then, enter an encryption code of eight or more alphanumeric
characters in the Encryption Key field.

9. Click Submit.

Command Buttons

The following command buttons are used throughout the Web interface panels for the switch:

Save

Pressing the Save button implements and saves the changes you just made.
Some settings may require you to reset the system in order for them to take
effect.

Refresh

Pressing the Refresh button that appears next to the Apply button in Web
interface panels refreshes the data on the panel.

Submit

Pressing the Submit button sends the updated configuration to the switch.
Configuration changes take effect immediately, but these changes are not
retained across a power cycle unless a save is performed.